Monday, June 19, 2017

Diamond Shaped Lidded Box



Hello Hivers,

You all know I love making 3D projects.  I saw this cute little box on Pinterest.  The measurements were in cm so I had to do some recalculations to make it using inches.   My dear sister bought me a big box of Ferrero Rocher chocolate candies for Mother's Day.  I thanked her then laughed.  I knew that I would be making some type of box to put them in.  I used the Eastern Palace Specialty Designer Series Paper along with Fresh Fig, Lemon Lime Twist, Berry Burst, and Dapper Denim card stock.  A few small circle punches and the Eastern Beauty stamp set finished the boxes.  I decided to add a little bit of the Gold Metallic Thread to one of the boxes.  Each box holds just one of the Ferrero Rocher chocolates.


WRITTEN TUTORIAL

BOX LID
3-1/16" x 3-1/16"
Score at:  3/4" on all for sides


DSP
1-3/8" x 1-3/8" (1)
5/8" x 1-3/8" (4)

BOX
 6-7/8" x 3-1/8"
Score short side at:  1-9/16" and 2-3/8"

Turn card stock and Score with the Bigger section at the top at:  1-9/16", 3-1/8", 4.75", and 6-5/16"

Now with the Smaller section at the top Score at:  1-3/8", 2-15/16", 4.5", and 6-1/8"

You will need to add some diagonal score lines as shown below.


When cutting up the bottom flaps, only cut away the score line or less.






As always, thanks for Buzzzing by the Hive today.
Until next time....Buzzz you later.
SaveSaveSaveSaveSaveSave

No comments:

Post a Comment